Colortrac SmartLF Installation and Operating Manual
PAS144 P/N: P002038 Colortrac Ltd © 2004
5
4. REMOVING THE SHIPPING PROTECTION AND SETTING UP SMARTLF
Before attempting to use SmartLF it is essential that the shipping protection which protects the scan glass is removed
from inside the scanner:
•
Open the SmartLF lid ......................see section 5. Opening the SmartLF lid
•
Remove the piece of foam and retain with the packaging for the scanner. If you need to transport the scanner later you will need to replace this
item to protect the scanner optics.
•
Close the SmartLF lid .....................see section 6. Closing the SmartLF lid
•
Fit the three paper support trays by compressing (springing) them into the slots on the back of the scanner
•
Connect the scanner to the local electricity supply using the cable provided
IMPORTANT – DO NOT CONNECT THE SCANNER TO THE COMPUTER UNTIL INSTRUCTED
5. OPENING THE SMARTLF LID
The SmartLF lid is in two parts, the complete lid, which is opened to allow cleaning of the scan glass and the
lightweight cover part which can be opened to permit adjustment of the document scanning pressure.
To raise the whole lid first PRESS IN AND PUSH UPWARDS the two side catches. With the catches pressed in, use
the forefingers and thumbs to lift the lid slowly upwards in an arc on its rear hinges. The lid will lock in a position
leaning slightly backwards from the vertical.
During opening the catches can be ‘latched’ to prevent damage to the end mouldings when the lid is closed later.
Alternatively remember to squeeze the catches inwards towards the centre of the scanner when lowering the lid back
down again. DO NOT try to lower the lid with the catches in the locked position.
Lid showing latches in the LID CLOSED or
OUT position. The lid is heavy but will lock
in the upright position (about 110º). It is
recommended that the operator avoid
leaving the scanner unattended while the lid
is open.