Page | 36
VERVE LED
14. Media Loading
Follow these steps to load the media on the machine:
Follow these steps to load media:
Step 1:
Place the media on the Print Bed.
Step 2:
Switch ON the Print Bed vacuum by pressing the
Bed Vacuum
button available on the front side
of the machine, as shown below:
Fig 41: Turning ON the Bed Vacuum Button
Step 3:
Switch ON the required vacuum chambers by moving the Vacuum Chamber knob, as shown below:
Fig 42: Switch ON the Vacuum Chamber
The classification of Vacuum Chamber on the Print Bed is shown as below:
Fig 43: Classification of Vacuum Chamber on the Print Bed
Step 4:
Set the head height using the
Measure paper width
icon on the Quick Access Toolbar.
Now, the media gets loaded in the machine.
