Page | 43
TXF
Issuing the TEST PRINT Command
Follow these steps to perform test print:
Step 1:
Set the print origin by following all the steps mentioned in the
“Setting Print Origin”
section.
Step 2:
Press the
TEST PRINT
button from the Control Panel of the print engine and hold it for few
seconds.
The following test print is printed on the fabric, as shown below:
Fig 54: Showing the TEST PRINT Result
In the above figure, you can see that few nozzles are not firing. Thus, to overcome from this situation, we
recommended to use head cleaning methods to clean print head for quality printing.
