Page | 21
TXF
Tightening the Conveyor Belt
Follow these steps to tight the Conveyor Belt:
Step 1:
Tighten the adjustment rings on the right and left sides of the belt in the rear, using a pair of pliers.
Step 2:
Make sure that tighten the rings on the right and left sides with the same torque.
Step 3:
Rotate the both rings for the same number of times, as shown below:
Fig 10: Tightening the Conveyor Belt
Now, the Conveyor Belt gets tighten.
Checking the Belt Movement
Follow these steps to check the belt movement:
Step 1:
Switch ON the Conveyor Belt.
Step 2:
Run the Conveyor Belt for a long time (Around 30 minutes) to check the movement and direction
of it.
Step 3:
Check the shifting of Conveyor Belt to control it, if required.
If the Conveyor Belt is shifted or not in center, then it need to be adjusted (Refer to upcoming section).
