Page
26
of
50
SOFTJET GRAND
10. Head Installation
Use this section, if Print Head is not installed in the printer.
The installation of Print Heads is to be done only by a service engineer. If the Print Head is not installed
correctly, it can affect the printing quality.
Note: Don’t apply much pressure on
Print Head
while handling it.
Follow these steps to install the Print Head:
Step 1
: Remove the
Ink Inlet caps
gently to avoid damage to the Print Head, as shown below:
Fig 29: Removing the Ink Inlet Caps
Step 2:
Fix the
Air Releasing pipe
on one end of the
Ink Inlet Tube
, as shown below:
Fig 30: Fixing the Air Releasing Pipe
Step 3:
Remove the
Nozzle Cap
from the Print Head (Refer to Fig 30).
Note:
Don’t put the Print Head (nozz
le facing) on the rough or dusty surface.
Step 4:
Mount the
Print Head
in the slot on the
Head Plate
(Refer to Fig 30).
Nozzle Cap
Air Releasing Pipe
