www.coloradotime.com
51
Diagnostic Testing
The Gen7 diagnostics helps find issues with both in-deck and on-deck wiring as well as with
touchpads, pushbuttons and RJPs. Here are the steps to fully test the entire system:
1. Connect all the hardware that will be used:
a. If using bulkheads or cable-harnesses, make sure those are plugged in to the
appropriate deckplate, wallplate or timer connection.
b. Touchpads, pushbuttons and RJPs should be plugged in to deckplates or cable
harnesses.
2. When the pool is empty, start Real Time diagnostics.
All inputs should show up as Open
a. If you see any inputs register as Shorted
, Corroded
, or Closed
,
use the table below to determine next steps.
3. After ensuring that all inputs are registering as Open, stop the real-time test and run a
pre-meet test.
4. Walk the pool deck and trigger each touchpad, pushbutton and RJP. Each input should
show up as Closed.
a. If any inputs register as Shorted, Corroded or Closed, use the table below to
determine next steps.
Status
key
Start and
Stop test
Pre-Meet/ Real
Time drop down
