e-mark create marking device
Chapter 5 Operation
CODI Standard 1.0
29/60
Operating and Maintenance Manual
3. In the app, the WIFI symbol
confirms a WIFI connection.
Or if connected by the USB cable:
1.
The e-mark create is connected by USB cable to the computer
Image transfer:
Refer to the software description for details.
Acoustic and optical signals:
During image transfer to the e-mark create, the Light Guide flashes blue continuously and a long signal
sounds when the transfer is complete.
NOTICE
Saving the image file can take several seconds. Do not switch off the e-mark create
before you hear the double beep confirming the saving process has been successful,
otherwise saving is interrupted.
Image saving:
The e-mark create takes time to save the newly transferred image to the internal Flash memory. During the saving
time, the Light Guide displays a continuous purple flashing LED. Do not switch off the e-mark create during the saving
process, otherwise the image will not be saved correctly. A brief signal sounds at the end of the saving process.
5.2 Printing
Switch on the e-mark create (in the docking station) by sliding the switch from OFF to ON. The Light Guide shows
that the e-mark create is powering up (flashing green LED).
The e-mark create is held in the docking station by magnets.
Fig. 16: On/off switch
1. Switch on the e-mark create by sliding the switch from the OFF to the ON position (Fig. 17).
2. Wait until the Light Guide indicates that printing can begin (back left green light on continuously)