Shaker
AGIA 200, VIBA 300 & VIBA 330
Collomix GmbH
D-85080 Gaimersheim
12
Version G 1.4-16
6.
Operation
Prior to working with the machine, check all parts for their proper condition and function. Do not
start the machine with defective or missing parts.
WARNING
Risk of injury by machine parts that continue to rotate
After the machine is turned off, there are still rotating parts that can cause injuries.
•
Never stop the machine by hand.
Check all safety-relevant structural components of the machine for proper function before starting
it. Any defective or damaged parts must be replaced by qualified personnel prior to starting to work
with it.
6.1
Switching on the machine
The machine is turned on using the main switch (4).
After an automatic initialisation, READY is shown on the display.
Any errors detected during initialisation are shown in text form on the display.
6.2
Load a container
To place the container, proceed as follows:
Open the door by pushing the DOOR button.
To adjust the mixing unit to the height of the container, use the E-Button to raise the clamping
plate.
Pay attention to the allowable height, weight, and dimension of the mixing container. Do not
overload the machine.
Secure the container handle with clamping rubber or an adhesive tap and centre it on the mixing
table.
Several identical containers can be mixed at the same time. Pay attention to a symmetric
arrangement of the containers on the mixing table.
IMPORTANT
If you use larger containers, it is recommended to insert an additional filler disk made of foam.
However, the filler disk should not be higher than the rim of the cover. It reduces the membrane
effect of the cover and the running noise is reduced.
Place containers always in the centre
.
Do not stack containers!
Filler disk