4D BATTERY QUICKPUMP™
INSTRUCTIONS
(Photo may vary from actual product.)
Warning
Things You Should Know
• Children shall not play with the appliance.
Cleaning and user maintenance shall not
be made by children.
• Follow the instructions carefully on articles
to be inflated, never exceed recommended
pressure. Bursting items can cause
serious injury.
• There are no user serviceable parts.
• Do not use under wet conditions. Keep
away from water.
• Never look into or point any opening toward
your eyes while pump is operating.
• Do not attempt to put any objects into the
inflation or deflation port at any time.
• Never leave pump unattended while in use.
• Never allow sand, paper, debris or small
articles to be sucked into pump
while operating.
• Motor may be hot. Use caution when
replacing batteries.
• Let pump cool before storing the pump
inside the box after use.
Do not operate pump continuously for
more than 15 minutes. Allow 10 minutes
OFF between each operation.
CAUTION: Do not block the air portals
during operation, this could damage
the motor.
• Inflates AND deflates.
• Adaptor works with Coleman
®
Double
Lock™ Valve as well as other airbed valves
on the market.
• Operates on four D-cell batteries.
• Carefully inspect the pump for damage
before first use and every use thereafter.
Do not use if found damaged.
• Keep unit out of reach of children.
• Do not expose to rain or sunlight.
Household use only.
• This pump is a high-volume, low-pressure
pump. It is intended to inflate items
requiring low pressure (such as inflatable
beds, inflatable rafts, air mattresses, etc.).
• For fast inflation and maximum motor
cooling, always use the largest size nozzle
possible.
Note:
Pump will not work on stem valves or
needle valves commonly used on bike tires,
basketballs, etc.
• Always purchase the correct size and
grade of battery most suitable for the
intended use.
• For optimum performance alkaline
batteries are recommended.
• Replace all batteries of a set at the
same time.
• Clean the battery contacts and also those
of the device prior to battery installation.
• Ensure the batteries are installed
correctly with regard to polarity (+ and –).
(see Fig. 7)
• Remove batteries from equipment which
is not to be used for an extended period
of time.
• Remove used batteries promptly.
