REFER ALSO TO MAIN
INSTRUCTIONS FOR AV/VC
ONE STAND INSTALLATION
Installation Instructions for
AV/VC One Codec Mount
A V S / 0 2 1 / C O D 1
P A R T S I N C L U D E D :
Codec
mount
Velcro
strap
IMPORTANT NOTE
Choose mounting position
in AV/VC One column
according to preferred
arrangment or convenient
cable paths.
AVS-021-COD1-INST-A-MAY 2016
W A R N I N G
• Do not install equipment heavier than 1kg/2.2lb.
• Use with products heavier than the maximum weights indicated may result
in instability causing possible injury.
• Correct installation is essential to safe and reliable operation of the
AV/VC One product and falls outside the scope of responsibility
of Colebrook Bosson Saunders. Please follow assembly instructions carefully.
• Do not use this product for any purpose other than that for which it
was designed.
• Ensure that floor or wall surface is strong enough to support the weight of
the fully-loaded AV/VC One and that the floor surface is flat and level.
• Do not install AV/VC One outdoors or in environments where it will be
directly exposed to moisture or highwinds.
• Follow the manufacturer’s guidance for mounting of monitors, displays
and other equipment.
• Please take care to avoid trapping fingers when installing or adjusting
the product.
E L E C T R I C A L S A F E T Y
• Safe installation of electrical equipment is the responsibility of the installer.
• Colebrook Bosson Saunders recommends that only double-insulated
electrical equipment and cables are installed in AV/VC One unit.
M A I N T E N A N C E A N D I N S P E C T I O N
• Ensure all screws and fixings are fully tightened and occasionally re-tighten if necessary.
• Clean with a dampcloth. DO NOT use solvents.
D I S C L A I M E R
As part of Colebrook Bosson Saunders ongoing product improvement
programme, the design of products may change without prior notice and
details may vary from those illustrated.
AVS/021/COD1
