matrIQ Optical Switch
|
matrIQ Switch
Coherent Solutions Ltd.
Version
1.03
8
4
Connecting Optical Input
I
MPORTANT
To ensure maximum power and to avoid erroneous readings always
inspect fiber end faces. Make sure they are cleaned as detailed below
before inserting into any port. Coherent Solutions is not responsible for
damage or errors caused by bad fiber cleaning or handling.
C
AUTION
The type of optical connectors on the matrIQ Switch instrument can be
found printed on the front plate of the module. Joining mismatched
connectors will damage the ferrules and fibre faces.
Cleaning and Connecting Optical Fibers
To connect the fiber-optic cable to the port:
1.
Inspect the fiber using a fiber inspection microscope. If the fiber is clean, proceed to
connect it to the desired port. If the fiber is dirty, clean it as detailed below.
2.
Clean fiber ends as follows:
a
Gently wipe the fiber end with a lint-free swab dipped in isopropyl alcohol.
b
Use compressed air to dry completely.
c
Visually inspect the fiber end to ensure its cleanliness.
3.
Carefully align the connector and port to prevent the fiber end from touching the outside
of the port or rubbing against other surfaces. If the connector features a key, ensure that
it is correctly mated into the corresponding notch of the port bulkhead.
4.
Push the connector in so that the fiber-optic cable is firmly in place, thus ensuring
adequate contact. If your connector features a screw sleeve, tighten the connector
enough to firmly maintain the fiber in place. Do not over tighten, as this will damage the
fiber and the port bulkhead.
Note:
If your fiber-optic cable is not properly aligned and/or connected, you will notice large
signal loss and reflection
.
Coherent Solutions uses high quality connectors in compliance with EIA-455-21A standards.
To keep connectors clean and in good condition, Coherent Solutions strongly recommends
inspecting them with a fiber inspection probe before connecting them. Failure to do so will
result in permanent damage to the connectors and degradation of future measurements.
