Connect an RS-232 Serial Cable (Optional)
To connect the vision system to a serial device, plug an RS-232 serial cable (DB9 connector) into the I/O module’s
RS-232 port and connect the other end of the cable to the serial device. Tighten the connector screws to secure it to the
I/O module.
Note
: When the In-Sight 7000 series vision system is configured for use with the CIO-MICRO or CIO-MICRO-CC I/O
module, the RS-232 TRANSMIT and RS-232 RECEIVE pins on the Breakout cable are disabled. Use the I/O
module's RS-232 port (DB9) to connect to a serial device.
Connect an RJ-45 LAN Cable
To connect the vision system to an Ethernet network, plug a LAN cable (RJ-45 connector) into the I/O module’s LAN port
and connect the other end of the cable to a switch/router or PC, as applicable.
17
Installation
