Connect the Ethernet and Power
The vision system’s PoE connector provides the Ethernet connection for network communications and supplies power to
the vision system. The following steps illustrate how to connect the vision system to the In-Sight CIO-MICRO I/O module.
If the CIO-MICRO I/O module is not used, a third-party PoE injector or a PoE switch must be used to supply power to the
vision system.
Note
: The CIO-MICRO I/O module does not support 1000 BaseT pass-through operation. If 1000 BaseT operation
is required, you must connect an RJ-45 LAN cable from a Gigabit PoE switch to the I/O module’s LAN port and
connect the vision system’s Ethernet cable to the Gigabit PoE switch.
Connect the Power Wires
CAUTION
:
Never connect the I/O module to a power source other than 24VDC. Any other voltage creates a risk of
fire or shock and can damage the hardware. Do not connect the 24VDC power source to any terminals other than
the 24VDC + and – power terminals.
1. Verify that the 24VDC power supply being used is unplugged and not receiving power.
2. Use a screwdriver to loosen the I/O module's power terminals (labeled 24VDC + and –).
3. Insert the 24VDC + and – wires (16 - 22 AWG, solid or stranded wire) from the power supply into the 24VDC +
and – terminals on the I/O module.
4. Tighten the screw terminals with the screwdriver to secure the wire leads in the terminal block; the maximum
torque is 0.1921 Nm (1.7 in-lb).
18
Installation
