Cognex In-Sight 7600, Reference Manual

Page: 93 / 113

Breakout Cable
The Breakout cable provides connections to an external power supply, the acquisition trigger input, general-purpose
inputs, high-speed outputs, and RS-232 serial communications. The Breakout cable is not terminated.
Pin#
Signal Names
Wire Color
1 IN 2 / HSOUT 2 Yellow
2 RS-232 TRANSMIT White/Yellow
3 RS-232 RECEIVE Brown
4 IN 3 / HSOUT 3 White/Brown
5 IN 1 Violet
6 COMMON IN White/Violet
7 +24VDC Red
8 GND Black
9 COMMON OUT Green
10 TRIGGER Orange
11 HSOUT 0 Blue
12 HSOUT 1 Grey
Note :
l
Cables are sold separately.
l
Perform wiring or adjustments to I/O devices when the vision system is not receiving power.
l
You can cut exposed wires short or trim wire ends. You also can tie the wires back if you use a tie made of
non-conductive material. Keep bare wires separated from the +24VDC wire.
l
When using the 15 meter Breakout cable, full 24VDC voltage must be maintained at the input leads of the
Breakout cable when the vision system is operating.
l
If hardware handshaking is required for serial communication, an I/O module must be used.
93
Specifications