Cognex In-Sight 7600, Reference Manual

Page: 75 / 113

7800/7801/7802 Vision System Specifications
Specifications 7800 7800C 7801 7801C 7802 7802C
Minimum Firmware
Requirement In-Sight
version 5.4.0 In-Sight
version 5.5.0 In-Sight
version 5.4.0 In-Sight
version 5.5.0 In-Sight
version 5.4.0 In-Sight
version 5.5.0
Job/Program Memory 7.2GB non-volatile flash memory; unlimited storage via remote network device.
Image Processing
Memory 512MB SDRAM
SD Card 1 Micro SD card slot with an 8GB SD card pre-installed for saving job and image files. The
vision system supports SD cards with a maximum capacity of 32GB, formatted with a FAT32
file system.
Sensor Type 1/1.8-inch CMOS, global shutter
Sensor Properties 800 x 600: 4.5mm diagonal,
4.5 x 4.5µm sq. pixels 7.38mm diagonal, 4.5 x
4.5µm sq. pixels 1600 x 1200: 9mm diagonal,
4.5 x 4.5µm sq. pixels
640 x 480: 3.6mm diagonal,
4.5 x 4.5µm sq. pixels 800 x 600: 9mm diagonal, 4.5
x 4.5µm sq. pixels
Maximum Image
Resolution (pixels)
1
800 x 600
2
1280 x 1024 1600 x 1200
3
640 x 480 800 x 600 (Low Light Mode)
Electronic Shutter
Speed 800 x 600: 14µs to 550ms 17µs to 750ms 1600 x 1200: 20µs to 940ms
640 x 480: 14µs to 520ms 800 x 600 (Low Light Mode):
20µs to 940ms
Acquisition Rapid reset, progressive scan, full-frame integration.
Bit Depth 256 grey
levels (8
bits/pixel) 24-bit color 256 grey
levels (8
bits/pixel) 24-bit color 256 grey
levels (8
bits/pixel) 24-bit color
Frames Per Second
(FPS)
4
800 x 600:
165 FPS 800 x 600:
100 FPS 76 FPS 45 FPS 1600 x 1200:
53 FPS 1600 x 1200:
33 FPS
640 x 480:
217 FPS 640 x 480:
135 FPS
800 x 600
(Low Light
Mode): 53 FPS
800 x 600
(Low Light
Mode): 45 FPS
Lens Type C-Mount or S-Mount/M12
Trigger 1 opto-isolated, acquisition trigger input.
1
You can configure the number of image sensor rows and set them in the In-Sight Explorer software. If you decrease the number of rows, it
increases the frames per second acquired by the vision system. Refer to the AcquireImage topic in the
In-Sight
®
Explorer Help file for more
information.
2
The default resolution is 800 x 600 pixels. The resolution can be configured as 640 x 480 pixels within the In-Sight Explorer software.For more
information, see the
In-Sight
®
Explorer Help file.
3
The default resolution is 1600 x 1200 pixels. The resolution can be configured as 800 x 600 (Low Light Mode) within the In-Sight Explorer
software. When using 800 x 600 (Low Light Mode), it provides increased light sensitivity at a reduced resolution. For more information, see the
In-Sight
®
Explorer Help file.
4
Maximum frames per second are job-dependent, based on the minimum exposure for a full image frame capture using the dedicated
acquisition trigger, and assumes there is no user interface connection to the vision system.
75
Specifications