Cognex In-Sight 7600, Reference Manual

Page: 46 / 113

Install the Converter Mounting Bracket (ISB-7000-7K)
Complete the following steps to attach the converter accessory mounting bracket (ISB-7000-7K) to the vision system.
Note : When attaching the vision system to the mounting bracket, use the M3 screws supplied with the mounting kit.
If using the 1/4 - 20 or M6 screw holes, the thread length of the screw should not exceed 7mm. For more
information, see
Converter Mounting Bracket (ISB-7000-7K) on page 106 .
CAUTION : The vision system should be grounded, either by mounting the vision system to a fixture that is
electrically grounded or by attaching a wire from the vision system’s mounting fixture to frame ground or Earth
ground. If a ground wire is used, it should be attached to one of the four mounting points on the back plate of the
vision system and not to the mounting points on the front of the vision system.
1. Align the converter mounting bracket with the mounting holes on the vision system.
2. Insert the M3 screws into the mounting holes and tighten using a 2.5mm hex wrench. The maximum torque is
0.90 Nm (8 in-lb).
46
Installation