Chapter 1: Setting up Your In-Sight 1010
1
Chapter 1: Setting Up Your In-Sight 1010
This document is a guide to setting up your In-Sight 1010 system to read barcodes and 2D
matrix codes.
Connecting the In-Sight 1010
Refer to
Installing the In-Sight 1000
, which is included with your In-Sight 1010 system on the In-
Sight CD-ROM. This explains how to connect the system directly to your PC, an In-Sight 3000,
or an Ethernet network. Once you have completed the system installation described in
Installing
the In-Sight 1000,
proceed to the next section,
Loading the Jobs from the CD
.
Loading the Jobs from the CD
1. Place the In-Sight 1010 CD-ROM in your PC’s CD-ROM drive.
2. The In-Sight 1010 Setup Wizard should start automatically, see Figure 1-1.
3. If the Setup Wizard does not start automatically, click on the Windows Start button and
select Run, then enter
[x]:\IS-1010.exe
, where
[x]
is the drive letter of your CD-ROM
drive.
Figure 1-1. In-Sight 1010 Setup Wizard
4. Follow the directions provided by the Wizard. When it finishes, reboot your In-Sight 1010.
