24
DEC 2021
INSTALL GUIDE
2
SOFTWARE SETUP
COGNEX DataMan 374
REV 00
2.6
READER CALIBRATION
1. Once the label has successfully been displayed in the reader alignment test,
select ‘
Calibrate Reader
’ as shown in Figure 2.23.
QTL-RND-SCR-00000247-A-00
Figure 2.23 – Reader calibration
2. Press ‘
Yes
’ to confirm and begin reader calibration as shown in Figure 2.24.
QTL-RND-SCR-00000248-A-00
Figure 2.24 –
Confirming reader calibration
3. While the reader is calibrating, progress information will display as shown in
Figure 2.25 until calibration has been completed.
QTL-RND-SCR-00000249-A-00
Figure 2.25 – Calibration progress information
4. Once calibration is complete run an alignment test again to ensure the
code/label content is displayed successfully, and then exit the Reader setup
screen to finish and complete the setup of the reader. See section
for further assistance.
