Industrial Protocols
The DataMan 360 readers support the following industrial protocols:
l
EtherNet/IP™
l
PROFINET
l
SLMP Protocol
l
Modbus TCP
Select industrial protocol samples and tools you want to use when you install the DataMan Setup Tool.
There are three ways to enable or disable industrial protocols. Using either method, a reboot is required for the changes
to come into effect.
l
Enable the protocols using the
Industrial Protocols
pane of the DataManSetup Tool (under
Communications
).
l
Scan the appropriate
Reader Configuration codes
(see
Reader Configuration Codes
available through the
Windows
Start
menu or the Setup Tool
Help
menu).
l
Send the appropriate
DMCC
(see
Command Reference
available through the Windows
Start
menu or the Setup
Tool
Help
menu).
For more information on using the industrial protocols, see the
DataMan Industrial Protocols Manual
available through
the Windows
Start
menu or the Setup Tool
Help
menu.
DataMan 360 Series Triggering
DataMan 360 readers support the following trigger modes:
l
Self
: At an interval you configure, the reader automatically detects and decodes codes in its field of view. If you
set a higher re-read delay than the trigger interval, there is a code output only once until the code is out of the
field of view for the duration of the re-read delay.
l
Single
(external trigger): Acquires a single image and attempts to decode any symbol it contains, or more than
one symbol in cases where multicode is enabled. The reader relies on an external trigger source.
l
Presentation
: Scans, decodes and reports a single code in the field of view. The reader relies on an internal
timing mechanism to acquire images.
45
Using Your DataMan 360
