ORIGINAL LINE M
8
Original instructions.
Warnings and Precautions
GENERAL INFORMATION
The appliance is not suitable for installation in an area where a
water jet could be used. This appliance must not be cleaned
with a water jet or a pressure washer.
The appliance is not suitable for outdoor use, where it would be
exposed to severe weather or extreme temperatures.
The instructions for appliances connected to the water mains by
detachable hose-sets shall state that the new hose-sets supplied
with the appliance are to be used and that old hose-sets should
not be reused.
Use the inlet hose included with the machine to connect it to the
water mains in accordance with the national rules applicable in the
country where machine is installed.
Plug the machine into a properly installed, earth grounded electrical
outlet with line voltage that matches the specifications for the machine.
For appliances not fitted with a supply cord and a plug, means for
disconnection must be incorporated in the fixed wiring in accordance
with the wiring rules.
Ensure that the power supply voltage does not fluctuate by more than 6%.
Position the power cable so that users cannot trip over it. Keep the
power cable away from sharp edges and heat sources.
Do not remove or disable any of the mechanical, electrical, or thermal
protection safety equipment.
If supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
In case of emergency, (e.g., the machine catches fire or becomes
unusually hot or noisy), disconnect the power immediately and turn
off the water supply.
If the machine is not going to be used for an extended period of time,
disconnect the power. When disconnecting the power, pull the plug
rather than the cable.
Keep all hazardous packaging materials, such as plastic bags,
styrofoam, and staples, out of reach of children.
Before performing maintenance and/or moving the machine, disconnect
the machine from the power supply and wait for it to cool down.
To ensure fault-free machine operation, only use manufacturer-
approved replacement parts and accessories.
