CodaOctopus F175 MOTION, Manual

Page: 16 / 27

Setup MOTION Control
Copyright © 2013 Coda Octopus Products Ltd
16
F175 MOTION Sensor - Trimble SPS361/SPS461 Integration
4 Setup MOTION Control
Connect the Serial Output you have chosen on the Trimble SPS361/SPS461 to the External
GNSS Port on the F175 System.
Start MOTION Control and click the Ethernet button to connect to the F175 System.
Figure 3: Ethernet Data Source Button in MOTION Control
Once the Connection is established start the MOTION Settings Wizard and setup the GNSS
Selection to Trimble: 361 or Trimble: 461 .
Figure 4: MOTION Settings Wizard - GNSS Settings
Complete the remaining steps in the wizard and upload the settings to the F175 System.
NOTE: Antenna Splitters can be used for both internal primary and (if using Trimble
SPS461) secondary antenna. The measurements in the MOTION Settings Wizard
should then relate to the antennas in use. Please also consult the chapter about
Use
of Antenna Splitters for further important information.