EN
G
LI
S
H
9
Features
Power switch and forward/reverse selector
1. The direction of rotation (forward or
reverse) can be chosen using the selector
(4). The rotation selector also has
a middle setting which locks the power
trigger. If the selector is set to this middle
position, the drill/driver will not start.
2. The drill/driver is started and stopped
by squeezing and releasing the power
trigger (5). The drill/driver is equipped with
a variable speed control, which makes
it extremely practical for driving screws.
The more the power trigger is squeezed,
the higher the chuck rotation speed.
Work light
The drill/driver is equipped with a work light (11). The light comes on when the power
trigger is squeezed and goes off when the power trigger is released.
Battery charge status indicator
The battery has a charge status indicator (8)
consisting of 4 LEDs and which is activated
by pressing the test button (9).
One or several LEDs become lit depending
on the battery status:
• The battery is fully charged, 1 red and
3 green LEDs.
• The battery is partially discharged, 1 red
and 1–2 green LEDs.
• The battery is discharged and must be
recharged if just 1 red LED is lit.
Screwdriver mode
1. Use the torque/drill mode selector ring (2) to set a suitable torque setting.
The correct torque setting will disengage the drive at the preset torque to prevent
screws from being over-tightened or driven in too far. The torque setting should be
based upon the type of screw, its size and the type of material being screwed into.
2. Always start at the lowest torque setting and increase in stages until a suitable
setting is reached.