EN
G
LI
S
H
10
Drill mode
Set the drill/torque setting ring (2) to drill mode ( ).
High/Low gear
The gear selector (3) has two settings: Mode 1: 0–350 rpm, mode 2: 0–1300 rpm.
Charging
Note:
The battery needs to be charged fully before initial use.
1. Remove the battery from the drill by pressing the battery release button (10) and
pulling out the battery. If the battery feels hot after heavy use, allow it to cool
properly before charging it.
2. Connect the charger to a wall socket. The green LED on the charger will come on.
3. Insert the battery into the charger. The LED will be lit a solid red during charging
and will change to a solid green once charging is complete.
4. Once charging is complete, press the battery release catch and remove it from
the charger.
The charger indicates the charging status as follows:
No battery connected:
• Constant green light: Charger is plugged into the wall socket.
Battery connected:
• Constant red light: Charging is in progress.
• Constant green light: Charging is complete, battery fully charged.
• Charging time: approx 1 hour.
• The battery may become warm during charging. This is completely normal.
• The battery and charger function best at normal room temperature. Do not charge
the battery in direct sunlight or in temperatures below 5 °C. The temperature range
for charging is 10–40 °C.
• When the battery becomes discharged, the electronics of the battery will turn
the drill off automatically.
• For long-term storage (months) the battery should first be fully charged.