®
23801 E. La Palma Ave., Yorba Linda, Ca 92887 Ph. 714.692.8180 Fax. 714.692.5016
www.cobrausa-hd.com
04/17
®
*
Cobra
®
recommends you always wear a helmet while riding. Please never operate your motorcycle while under
the influence of alcohol and/or drugs. Enjoy the new look of your motorcycle and please ride safely.
Items Supplied >
1 - Sissy Bar w/ Pad and Chrome Insert
2 - Mount Brackets (Left/Right)
2 - Detachable Side Plates (Left/Right)
2 - Front Mounting Bushings
2 -
3/8”-16 x 2” Buttonhead Bolts
4 -
M8
x 20mm Buttonhead Bolts
Application(s) >
HARLEY:
FXD SUPERGLIDE 06-10
FXDB STREET BOB 06-17
FXDC SUPERGLIDE CUSTOM 06-14
FXDL LOW RIDER
06-09, 14-17
Instruction Manual >
Read all instructions carefully before installing your new Cobra
®
product!
1.
If the motorcycle is equipped with rear reflectors than they must be removed along with any remaining
adhesive left on the motorcycle. Save the reflectors for reuse.
2.
Apply masking tape to the fenders above the fender rail to protect the paint during installation. See
FIGURE 1
.
3.
Remove the front bolt from the right side fender rail and discard.
NOTE:
Remove one side only so the
fender does not fall resulting in possible scratches or damage to the fender or paint. See
FIGURE 1
.
4.
Loosen the rear bolt securing the fender and rear turn signal from the inside of the fender until there is
enough space to insert the mount bracket. The rear hole in the mount bracket is slotted so it can slide
over the rear bolt so it does not need to be removed completely. See
FIGURE 1
.
5.
Pull the front of the inner nut plate away from the inside of the fender to allow clearance to insert the
front of the mount bracket. The boss on the front of the nut plate will insert through the large hole on
the front of the mount bracket. See
FIGURE 2.
602-2004/602-2004B
Page 1 of 4
DOCUMENT NO. 0017
REV. B
FIGURE 1
APPLY MASKING TAPE
TO PROTECT PAINT
REMOVE FRONT
BOLT
LOOSEN TURN
SIGNAL BOLT ON
INSIDE OF FENDER
CONTINUED ON PAGE 2