57
CAUTION:
Damage may occur if one attempts to install the water pump and the device is
not orientated correctly. If the tool does not sit flat against the cases, the
orientation of the tool to the engine is not correct. Make sure that the top
alignment pin is in the 2
nd
unthreaded hole, the bottom alignment pin is also in
the 2
nd
unthreaded hole, and that the relief for the stator bolt head is oriented
toward the stator.
10. Hold the installation tool firmly against the engine case and tap on the end of
the water pump shaft with a dead blow hammer until the insertion punch is
needed
11. Continue driving the assembly with the punch until the head is flush.
NOTE:
The insertion punch is 0.010” (0.25mm) longer than the housing so as to seat the
water pump assembly just in from the case surface.
12. The assembly is installed properly when the retaining screw can be tightened
and it does not cause a bind on the spinning shaft (use medium strength
thread lock on the retainer screw).
Summary of Contents for 2009 ECX50
Page 1: ......
