COBHAM SAILOR 60 GX, Installation Manual

Page: 166 / 192

98-148248-C E-1
Appendix E
EEEE
Command line interf
ace
Command line interface
E
E.1 Introduction
After you have done the initial configuration and connected the SAILOR VSAT system to
your network, you can use Telnet to configure the SAILOR VSAT system. You can also set
up VSAT modem parameters. Note that the following sections cover the command line
interface for all SAILOR VSAT antennas.
Some of the commands may not be relevant for the antenna described in this manual.
After successful login you can read and change settings. Use the command config
activate
to activate the new settings in the ACU. You will need to refresh the browser
window before the changed settings become visible.
E.1.1 Telnet connection
You can access the command line interface via Telnet.
Access to the SAILOR VSAT system system is protected by a user name and password. This
is the same user name and password that is used in the web interface under
ADMINISTRATION
.
The interface is on the standard Telnet port 23 or SSH port 22. Use any LAN port and
corresponding IP address of the ACU (except LAN 2 on GX/Ka ACU). To start telnet session
do as follows:
1. Open a Telnet client of your choice.
2. At the prompt, enter the IP address of the ACU, login
admin
and password.
Figure E-1: How to use the command line interface (example for telnet)
Note
Every change is performed on the active satellite profile or the
active VSAT modem profile. Parameter identifiers are case
sensitive.
H:\>telnet 192.168.0.1
acu login: admin
Password:
Connect to SAILOR
VSAT using IP address
UCLI:/$ config current_list
Read or change settings Write new settings to
SAILOR VSAT
1
2
3
UCLI:/$ config activate
Figure E-2: Command line interface, login