COBHAM SAILOR 60 GX, Installation Manual

Page: 137 / 192

Configuration of the dual antenna mode
98-148248-C Appendix B: Antenna Diversity Solution (ADS) B-7
BBBB
Anten
na Diversity
5. Select Enable and click Apply .
This SAILOR VSAT is now ready to act as Master ACU.
B.3.3 To configure the Slave ACU
The Slave ACU must be configured to use the Master ACU as a VSAT modem. The VSAT
modem profile must point to the IP address of the Master ACU, which is the IP address
192.168.1.2 of LAN 2 port to where the Master/Slave communication cable is connected.
The Slave antenna IP for LAN port 1 is automatically configured to IP:192.168.1.102.
To activate the ACU to be a Dual Antenna Slave do as follows:
6. Enter the VSAT modem profile name, for example
Dual Antenna Master
.
7. As modem select
Dual Antenna Master
.
8.
IP address
: this is the IP address of the LAN connector at the Master ACU (LAN1
always 192.168.1.2) which is used for modem communication (LAN1/LAN2).
9. Click
Apply
.
Figure B-4: Setup of the Master ACU
Important
Make sure that the IP addresses for LAN1/LAN2 of the Master ACU and the
Slave ACU are not identical.
Figure B-5: Setup of the Slave ACU 1/3