What’s in the box?
Dimensions for the SAILOR Fleet One antenna
Drilling plan for the SAILOR Fleet One terminal
The following items are included in the delivery:
• SAILOR Fleet One terminal
• SAILOR Fleet One antenna
• DC power cable (1 m) for the terminal
• Ethernet cable (2 m)
• I/O connector
• Mounting bolts and washers for the antenna
• RF cable (10 m)
• Kit for water protection of antenna connector joint
• Installation guide (this guide)
• Quick guide
• CD with User & installation manual, Installation guide and Quick guide
SAILOR Fleet One
Installation guide
Important notes for placing the antenna
• When mounting the antenna, make sure you do not block the drainage hole
in the centre bottom of the antenna.
• Leave space under the antenna for the antenna cable and connector
• Make sure the antenna has a free view to as much of the sky as possible.
Installing the SAILOR Fleet One System
1. Mount the antenna on a mast or on the hull using the enclosed mounting bolts.
Use the mounting bolts for grounding the antenna to the same ground as the
terminal.
• To mount the antenna on a mast, use the mast mount kit available from
Cobham SATCOM. The mast mount kit fits a 1½” pipe (OD 48.3 mm).
Instructions are included with the kit.
• To mount the antenna on the hull, use M6 mounting bolts and mount
spacers to avoid blocking the drainage hole in the bottom of the antenna.
The bolts must go 6 to 12 mm into the bushings in the radome. Fasten with
7 to 8 Nm torque.
2. Mount the terminal indoors on a flat mounting surface, e.g. on a bulkhead or
desktop, using four M5 screws of a type suitable for the mounting surface.
If the mounting surface is used for grounding, make sure that you have a good
electrical connection between the mounting surface and the terminal chassis.
Note: If you want to use the cable relief from Cobham SATCOM (Spare part no.
S-673738A) for the terminal, first remove the two rubber feet at the connector
end of the terminal. Then mount the cable relief in their place using two M4 x 6
mm countersunk screws.
3. Connect the cables as shown in the system configuration drawing (overleaf).
Power cable
Use the power cable supplied with the SAILOR Fleet One
System.
Connect the other end of the power cable to the
ship power supply . For wire colours in the power cable
see Connectors, pin allocation and wire colours (overleaf).
RF cable (antenna
cable)
Use the RF cable supplied with the SAILOR Fleet One System to
connect the antenna to the terminal. Seal the connection at the
antenna end using the enclosed kit for water protection.
4. If you are using a cable relief, secure the cables to the cable relief, e.g. using
cable strips.
Installation instructions
Cable relief (optional):
Remove the two rubber feet and mount the cable relief here.
Note: The drawings in this document are not drawn to scale. Refer to the dimensions written in the
drawing. All dimensions are in millimeters.
Note: The drawings in this document are not drawn to scale. Refer to the dimensions written in the
drawing. All dimensions are in millimeters.
Mast mount kit (part no. S-683742A-920 ) is not
included, but is available from Cobham SATCOM.
