COBHAM EXPLORER 7100GX, Installation And User Manual, Page: 68 / 78

List of events
B-2 Appendix B: System messages 98-147366-A
B.2 List of events
Error code
(ID)
Severity Description Explanation
08065-0 ADM WARNING GNSS data Missing GPS data (fix).
08067-0 ADM ERROR PCB temperature ADM temperature too high. The ACU is not
equipped with a fan, so make sure there is
compliance with the environmental
specifications.
0806A-0 ADM WARNING VMU connection The ACU has lost connection with the sat
modem.
0806C-0 ADM ERROR VMU frequency setup There is a mismatch in the frequency setup.
Probably the sat modem is not configured
correctly to match the requirements of the
ACU and antenna. A common mismatch is the
absence of Rx or Tx LO parameter in the VSAT
modem.
0806E-0 ADM ERROR VMU 10 MHz reference The VMU Rx or Tx reference signal is not
present. Whether this error Rx or Tx reference,
depends on the users selection on the modem
profile page. Make sure VMU Rx/Tx cable is
connected and that the VMU is configured to
output the RX/TX reference signal.
08078-0 ADM WARNING VMU TX frequency invalid VSAT modem unit provided a TX frequency of
zero. This may degrade tx performance. To
remove this warning re-configure the modem
to provide the correct tx frequency.
08104-0 ADM ERROR Antenna communication The ACU cannot communicate with the
antenna. Check cable and antenna.
08107-0 ADM ERROR ADM FPGA load The ADM FPGA cannot be initialised and
loaded.
0810A-0 ADM ERROR ADM production data Production data has been corrupted.
0810C-0 ADM ERROR File system integrity One or more file system partitions are corrupt.
You may have lost your settings and collected
statistics. If restarting the system does not
help, contact your service partner.
Table B-1: Event messages