Appendix B: Command reference
98-140012-H
AT commands
158
Parameters for context management AT commands
The table below summarizes the main parameters for the AT commands for context
management. For details, refer to the 3GPP standard TS 27.007.
Parameter
Values
Meaning
<apn passwd>
<apn passwd>
Password for the APN.
<apn uname>
<apn uname>
User name for the APN.
<apn>
<apn>
APN name.
<cid>
<cid>
The Context Identifier (1 – 11) for the PDP context.
If no cid is entered, the command applies to all defined PDP contexts.
<d_comp>
0
Data compression off (default if value is omitted)
<destination port
range>
<destination
port range>
Destination port range in the form
From.To
To indicate only one port number, type in the same port number under
From and To.
Example:
65333.65338 indicates port numbers from 65333 to
65338, both included.
<evaluation
precedence
index>
<evaluation
precedence
index>
The evaluation precedence index defines the order in which the traffic flow
filters are applied to packets. 0 is first, then 1, 2 etc.
<Guaranteed
bitrate DL>
<Guaranteed
bitrate DL>
0
The guaranteed bit rate down link (32, 64, 128).
If the parameter is set to '0' the subscribed value will be requested.
<Guaranteed
bitrate UL>
<Guaranteed
bitrate UL>
0
The guaranteed bit rate up link (32, 64, 128).
If the parameter is set to '0' the subscribed value will be requested.
<h_comp>
0
1
Header compression off (default if value is omitted)
Header compression on (manufacturer preferred compression)
<Max bitrate DL> <Max bitrate DL>
0
The maximum bit rate down link (32, 64, 128).
If the parameter is set to '0' the subscribed value will be requested.
<Max bitrate UL> <Max bitrate UL>
0
The maximum bit rate up link (32, 64, 128).
If the parameter is set to '0' the subscribed value will be requested.
<p_cid>
<p_cid>
The primary context to which the secondary context is related.
<packet filter
identifier>
<packet filter
identifier>
The packet filter identifier (1 – 8).
<PDP_addr>
<PDP_addr>
Omit this parameter - note that the comma must still be there if other
parameters come after this one.
