Chapter 4: To use the web interface
98-140012-H
Advanced settings
108
Security
To enable the use of Thrane IP Handset
1. From the
Advanced
page select
Security
.
2. Locate the field
Thrane IP Handset support
.
3. If you want the terminal to support BGAN profile and menu in Thrane IP Handsets, select
Support BGAN profile and menu in Thrane IP Handsets
.
This means that, in addition to making calls with the Thrane IP handset over the BGAN
network, you can use the handset display and keypad to:
• Enter PIN/PUK for the terminal.
• View pending alarms.
• View event log.
• View current satellite status and signal strength.
• Start/stop connection packages.
For details, see the user manual for the Thrane IP Handset.
To allow or block the use of AT commands on LAN/WLAN interface
AT commands are low-level commands used to control modems, in this case the
EXPLORER 710. They are typically used during service and maintenance or when
troubleshooting the terminal.
1. Under
Advanced
>
Security
, locate the field
AT commands
.
2. If you want to block the use of AT commands, remove the check mark at
Allow on LAN/
WLAN interface
(default allowed).
