Chapter 4: To use the web interface
98-140012-H
Advanced settings
96
To save or load a configuration
If you need to reuse a configuration in another terminal of the same type and software
version, you can save your current configuration to a file, which can then be loaded into the
other terminal.
To save a configuration to a file
To save the current configuration of your terminal to a file on your computer, do as follows:
1. In the
Advanced
page, click
Load/save configuration
.
2. Click
Save configuration
. The configuration file is saved in the EXPLORER 710.
3. Click
Download configuration...
The configuration is downloaded from the EXPLORER 710 to the downloads section of
your computer.
To load a configuration from a file
To load a configuration from a file into your EXPLORER 710, do as follows:
1. In the
Advanced
page, click
Load/save configuration
.
2. Click
Load configuration
.
3. Browse to the configuration file and click
Open...
The configuration is now loaded into your EXPLORER 710. When the configuration is
loaded successfully, the EXPLORER 710 restarts with the new configuration.
Connection watchdog (Link monitoring)
If you are
not
using the Terminal watchdog function (see
you can monitor the external IP connection of the EXPLORER 710 system using the
Connection watchdog. With this feature activated, the terminal will send out ping commands
(ICMP Echo Requests) to up to three servers of your choice.
Function of Connection watchdog
With the connection watchdog activated, the terminal will send out ping commands to up to
three servers of your choice. When a data session is started, the terminal will start sending ping
commands to the Primary IP address the number of times specified. If no response is received,
it will send the same number of ping commands to the Secondary and then the Tertiary IP
Note
Configuration files can only be exchanged between terminals with the same software
version!
