COBHAM EXPLORER 323, User & Installation Manual

Page: 96 / 158

Chapter 5: Configuration with web interface
98-169085-B Advanced settings 87
Remote management
You can set up the terminal so that it can be controlled from a remote location.
To set up the terminal for remote management, select
Advanced
>
Remote management
from the Control panel .
To set up remote access with IP
1. From the
Remote management
page, select
Enable access to web application
and/
or
Enable access to AT commands
.
2. Type in the
Incoming port
numbers to use for the web server and for AT commands.
The default port numbers are:
• web server: 80
• AT commands: 5454
Note
The settings for Remote access with IP are
not
relevant if you are using the
_IREMWEB
command. See To use AT commands to get remote access to the web
interface on page 136.
Note
If you type another port number, the port number must be available at your
service provider.