Chapter 5: Configuration with web interface
98-169085-B
Terminal settings
64
To select the preferred BGAN satellite
By default the terminal is set up to automatically find the most appropriate satellite to connect
to (Automatic mode). However, if you are located in an area with more than one BGAN satellite
available, you can select the satellite you prefer to use when the terminal registers on the
BGAN network. Do as follows:
1. In the
Terminal settings
page, locate the
Satellite selection
section.
2. Select the satellite you want to connect to, or select Automatic to let the terminal find the
most appropriate satellite.
3. Click
Save
.
To select the type of navigation system (GNSS)
To select which navigation system to use with your EXPLORER 323, do as follows:
1. In the
Terminal settings
page, locate the GNSS section (Global Navigation Satellite
System).
2. Select
GPS
,
GPS and GLONASS
or
GPS and BeiDou
.
3. Click
Save
. Note that it may take some minutes for the EXPLORER 323 to change the
navigation system.
To select the language
The default language of the web interface is
English
. You can change the language to
French,
German, Russian, Spanish, Portuguese,
Chinese
or
Japanese
.
To change the language, do as follows:
1. In the
Terminal settings
page, locate the
Language
section.
2. Select a language from the list and click
Save
.
