COBHAM AVIATOR 200, User Manual

Page: 69 / 126

Chapter 3: Operation
AVIATOR Wireless Handset menus 59
3333
Oper
ation
To set the country for Wireless network use
To make sure you have the right settings for the country your AVIATOR
Wireless Handset is currently located in, you have to enter the country in
the handset.
To enter the country, do as follows:
1. Select
Network > Settings > Country
.
2. Scroll to the country your handset is located in and select it.
If the country is not in the list, select
Other
.
To select the IP address mode
You can select whether or not the AVIATOR Wireless Handset should use
DHCP to automatically obtain an IP address. Static IP addresses are also
supported. It is recommended to use DHCP. Automatic IP (DHCP) is the
default setting.
To select the IP mode, do as follows:
1. From the main menu, select
Network
.
2. Select
Settings
.
3. Do one of the following:
• If the AVIATOR Wireless Handset
should use DHCP to automatically
obtain an IP address, check the box
next to
Automatic IP (DHCP)
and
select
Back
or press the on hook
key to exit completely.
• For a static IP address, clear the box
next to
Automatic IP (DHCP)
.
Then select
Yes
to confirm and continue to the next step.
Important
In some countries, the use of Wireless networks (WLAN) is
not allowed. Before continuing, make sure WLAN is allowed
and licensed in the country where you intend to use it.