98-175666-A
D-1
Appendix D
Command line interface
D
D.1 Supported connection modes
After you have done the initial configuration and connected the SAILOR XTR Ka to your
network, you can use SSH to configure the SAILOR XTR Ka. You can also set up VSAT
modem parameters. Note that the following sections cover the command line interface for
all SAILOR VSAT antennas.
Some of the commands may not be relevant for the antenna described in this manual.
After successful login you can read the settings.
SSH connection
You can access the command line interface via SSH.
Access to the SAILOR XTR Ka system is protected by a user name and password. This is the
same user name and password that is used in the web interface.
The interface is on the standard SSH port 22. Use any LAN port and corresponding IP
address (except LAN 2 on GX/Ka BDU). To start an SSH session do as follows:
1. Open an SSH client of your choice.
2. At the prompt, enter the IP address, login
admin
and password.
Telnet connection
You can access the command line interface via Telnet.
Figure D-1: How to use the command line interface (example)
H:\>telnet 192.168.0.1
acu login: admin
Password:
Connect to SAILOR
VSAT using IP address
UCLI:/$ config current_list
Read or change settings
1
2
Figure D-2: Command line interface, login
Important
Check that you have
Telnet access
enabled on the page
IoT &
Management
in the web interface.
