Satellite/modem profiles and blocking zones
98-166784-A
Chapter 6: Configuration
6-19
6666
Configuration
6.5.3
Setup of syslog
Remote syslog
You can set up the antenna to send each syslog message to a syslog server to advise the
system administrator of the current status of the antenna. To set up sending syslog
messages to a syslog server, do as follows:
1. Select
SETTINGS > Reporting
.
2. In the section
Remote syslog
select
On
to enable remote syslog (default:
Off
).
3. Enter the IP address of the syslog server to which the syslog messages will be sent.
4. Click
Apply
.
6.5.4
Administration
In this section of the web interface you can configure the following administrative settings:
•
To change the password and log out
•
To import and export a system configuration
•
To reset to factory default settings
Gateway setup
Set the following:
Default gateway source: Static
Default gateway:192.168.100.1
Zeroconf setup Set the following:
Zeroconf source: Disabled
Sections
Preferred use
Table 6-10: Setup of LAN connectors (Continued)
Figure 6-14: Web interface: SETTINGS, Reporting
