The web interface
98-165591-B
Chapter 4: Setup and operation
4-3
4444
4.1.2
Configuration web interface
Use the built-in web interface of the Base Unit to make a full configuration of the VSAT
system. You can use a standard Internet browser.
To access the configuration web interface
To access the web interface of the Base Unit do as follows:
1. Power up the VSAT system, i.e. switch on the Base Unit. Wait until the LEDs on the front
plate of the Base Unit show that the system is ready to be accessed.
• Power LED: Green
• Fail/Pass LED: Steady green.
2. Connect a PC to
Port 1
(Service port, standard Ethernet) of the Base Unit. You can also
connect to the WLAN interface if configured.
3. Open your Internet browser and enter the IP address of the Base Unit. The default IP
address is http://192.168.0.1. When the login page is displayed, you know that the
connection to the VSAT system can be established.
4. When prompted, enter user name and password.
• For first time use, see
New installation or forgotten password
further down.
• For details, see
Administrator access to the web interface (user name, password)
When you have entered the user name and password, the web interface is ready for use.
You can continue to configure the system.
Note
The settings specifically related to service are described in Chapter 5,
.
Note
If you are connecting a PC which is on a corporate network, do not connect to
Port 1 (configured as DHCP server). Connect to Port 4 instead (configured as
DHCP client).
Figure 4-1: Web interface > Dashboard
