2201R Mobile Tester SCPI Reference Guide
Chapter 2 Remote control of the 2201R Mobile Tester
47090/323
Copyright © 2016 Aeroflex Limited. All rights reserved.
24
Command commands
The common commands are understood by all SCPI and IEEE 488.2 instruments. Their purpose is to perform general
tasks and to read or work with the registers common to all SCPI instruments. The following common commands have
been implemented.
Command
Short description
Command group
:*CLS
Resets the entire status reporting
system.
General common commands
:*ESE
Sets and queries the event status
register mask.
Event status register
:*ESR?
Reads out the current contents of
the event status register.
Event status register
:*IDN?
Returns device identity.
General common commands
:*OPC
Waits until previous command
has been completed.
General common commands
:*RST
Resets the entire test set. All
parameters, limits etc. are set to
internally predefined default
values.
General common commands
:*SRE
Sets and queries service register
mask.
Service register
:*STB?
Returns the current contents of
the service register and clears the
service register.
Service register
:*WAI
Waits until previous command
has been completed.
General common commands