Cobalt Digital Inc BBG-1034-AUD-PRO-DSP, Product Manual, Page: 35 / 118

BBG-1034-AUDPRO-OM (V1.6) BBG-1034-AUD-PRO-DSP PRODUCT MANUAL
3-3
Setup/Operating Instructions
Connecting BBG-1034-AUD-PRO-DSP To Your Network
Connecting BBG-1034-AUD-PRO-DSP To Your Network
BBG-1034-AUD-PRO-DSP ships with network protocol set to DHCP and
populates its address with an addressed allocated by your DHCP server. If
your network does not have a DHCP server, the BBG-1034-AUD-PRO-DSP
address field will be blank, and a static address must then be assigned. All
initial network settings are performed using the Front Panel Display
menu-accessed control (as described on the previous page). Refer to this page
for instructions of using the front-panel menu navigation.
Access the Network Settings menu and configure network settings as follows:
1. Power-up BBG-1034-AUD-PRO-DSP and connect Ethernet cable connection to media. Wait for BBG-1034-AUD-PRO-DSP to
complete booting. When
Product: BBG-1034
... is displayed, device is ready for configuration.
2. Press and access the
Network Settings
menu. Current network settings are displayed (as configured by host DHCP
server).
Note: It is recommended to now change the settings to use a static IP address of your choice. The following steps describe using
a static IP address.
3. In
Network Settings > Mode
, change setting to
Mode: Static
.
4. Configure the following fields as desired and appropriate for your network connection (examples shown below).
Connecting BBG-1034-AUD-PRO-DSP To Network
Menu: Network Settings
IP: 10.99.16.105
Netmask: 255.255.255.0
Gateway: 10.99.16.1
Mode: Static
5. Press to commit changes and exit the setup menu.
Note: Current IP address of BBG-1034-AUD-PRO-DSP can now be checked from the front panel by accessing this at any point.
6. At this point, BBG-1034-AUD-PRO-DSP can now be accessed with a web browser pointing to the configured address. Browse to
the configured address and check connectivity.
X
Web browser pointing to configured address displays BBG-1034-AUD-PRO-DSP