BBG1002UDX-OM (V1.5)
BBG-1002-UDX PRODUCT MANUAL
3-57
Setup/Operating Instructions
BBG-1002-UDX Function Menu List and Descriptions
(continued)
• Moving Box Attributes Controls
Provides independent controls for setting the color and opacity of the
moving-box insertion.
• Color drop-down sets box color from multiple choices shown.
• Opacity controls sets box opacity from 0% (least opacity) to 100% (full
opacity).
Wings Insertion
Provides wings insertion/width controls and displays
insertion status.
• Wings Source Control
Selects the SDI input video port to serve as the device’s wings source.
Note: SDI inputs selected must be available on rear panel per model.
If FRC is being used by the scaler, wings source must be of
same frame-rate/raster format as scaled-to output. (For
example, if 720p5994 is being converted to 720p50, a
720p50 wings source must be used.)
• Wings Insertion Enable Control
Enables or disables wings insertion into the output video.
Note: For conditions where wings is not intended to be inserted, make
certain this control is set to Disabled.
• Wings Width Mode Control
Selects wings width control from the choices shown to the left and
described below.
• Manual: Wings L/R width is set using Wings Width manual control
(see below).
• Follow Scaler: Wings width automatically tracks with Scaler aspect
ratio control settings (as configured on wings host device).
Note: This function only tracks ARC settings applied locally on
the host device Scaler tab. Incoming AFD (if any) or
custom ARC performed on an upstream card/device is not
recognized by this function.
• Wings Manual Width Control
When Manual is selected above, allows symmetrical L/R wings insertion
width, from none to widths extending into active image area if desired.
(0 to 300 pixel range; null = 0)
Table 3-2
BBG-1002-UDX-UDX Function Menu List — continued
