BBG1002UDX-OM (V1.5)
BBG-1002-UDX PRODUCT MANUAL
3-69
Setup/Operating Instructions
BBG-1002-UDX Function Menu List and Descriptions
(continued)
GPO Setup Controls
Provides controls for setting up the two GPO’s
power-up states as well as forced manual or event
action triggered.
Note:
This tab has identical independent controls for GPO 1 and 2. Therefore, only the GPO 1 controls are described here.
• Current State indicates GPO status regardless of any pre-setup.
• Power-on State allows the power-up GPO state to be set
(initialized) upon power-up
• Control Mode allows GPO manual asserted open or closed states,
or hands over control to Event Action triggering.
Table 3-2
BBG-1002-UDX-UDX Function Menu List — continued
Download (save) presets to a
network computer by clicking
Download Presets – Save at the
bottom of the Presets page.
Browse to a desired
save location (in
this example, My
Documents\Cobalt
Presets).
The file can then be
renamed if desired
(RCVR21 Presets
in this example)
before committing
the save.
Upload (open) presets from a network
computer by clicking Upload
at the bottom of
DashBoard.
Browse to the location
where the file was saved
on the computer or
drive (in this
example, My
Documents\Cobalt
Presets).
Select the desired
file and click Open
to load the file to the
device.
Note: • Preset transfer between download and file upload is
on a group basis (i.e., individual presets cannot be
downloaded or uploaded separately).
• After uploading a presets file, engagement of a
desired preset is only assured by selecting and
loading a desired preset as described on the
previous page.
