3
9971-MVx-4K Function Menu List and Descriptions
3-30
9971-MVX PRODUCT MANUAL
9971-MVX-OM (V1.0B PRELIM)
Network Settings Controls
The Network Settings tab provides a dedicated Ethernet
connection to card control and monitoring via a rear
module Ethernet port. (This IP interface is entirely
independent and separate from the card’s DashBoard
frame-based remote control/monitoring interface.)
• Opening Fields for Editing
• Modify Network Settings button opens dialog field for setting
network parameters.
• Apply button commits and applies the settings.
• Cancel button exits dialog with no changes committed.
• Card IP Physical Port Select Control
Allows card dedicated IP interface (as set below) to use frame
communications or dedicated rear I/O module Ethernet RJ-45 port.
Note: • Frame net connection allows cards with per-card Ethernet
connection to connect with network via a shared frame Ethernet
port instead of per-card dedicated Ethernet connectors on the
card’s rear module. Frame net connection is available only on
certain frame models.
• Card slot must be fitted with a rear I/O module equipped with an
Ethernet connector in order to use Rear I/O selection.
• Card IP Setup Controls
Provides controls for setting up card dedicated IP interface.
• Addressing Mode selsects either DHCP or static.
• Where Static is selected, standard IP fields allow entry of Address,
Subnet Mask, and Default Gateway.
• Where DHCP is selected, DNS Server address field is provided.
• NTP Clock Setup
Allows device NTP clock IP source and localization. This is the clock/time
device will use for logs and other recorded actions.
• NTP Source buttons allow selecting the network source that will
provide NTP time.
• NTP Server sets the IP address where NTP is to be obtained when
“Specify IP Address” is checked.
• Card Active IP Address Display
Shows the connected (active) IP address the card is using (as set up
using the controls described above).
Admin
Shows card serial number.
Table 3-1
9971-MVx-4K Function Menu List — continued
