262 Owner’s Manual
6-3
Maintenance and Troubleshooting
Every 100 Hours
1. Clean the bilge area. Make sure all drain
passageways are clear. Refer to
Bilge
, in this
section, for cleaning instructions.
Monthly
1. Test the GFCI outlet circuit breaker feature if
equipped. Push the test button on each outlet.
Power should be interrupted to all the outlets
onboard. Press the reset button to restore
power. If power is not interrupted, consult your
authorized Cobalt dealer.
2. Check condition of all self-sacrificing anodes. If
anode shows deterioration of 50% or more, it
must be replaced. Refer to the propulsion unit
operator’s manual for additional information.
Quarterly
Have your authorized Cobalt dealer perform the
following scheduled maintenance:
1. Clean the fresh water filter.
2. Fill, pressurize and inspect the fresh water
system for leaks and proper component
operation.
3. Inspect the steering, shift and throttle systems
for proper operation.
4. Check all batteries for proper electrolyte level.
5. Check trim tab pump fluid level.
UNSCHEDULED
MAINTENANCE
A problem with a piece of equipment can occur at
anytime. Be aware of a malfunction. Have a
problem serviced immediately by your authorized
Cobalt dealer.
Engine/Propulsion/Cooling System
If a problem occurs with your engine, propulsion
unit or the cooling system between the scheduled
maintenance cycle, immediately notify your
authorized Cobalt dealer. Do not allow a problem to
go unattended. By doing so, a minor repair could
become a major overhaul.
Electrical System
Have your authorized Cobalt dealer repair all
electrical problems. An electrical problem must be
treated seriously.
Fuel System
Do not operate your boat knowing you have a fuel
system problem. Upon discovery of a fuel system
problem, immediately notify your authorized Cobalt
dealer for repair.
A
DANGER
Avoid the risk of injury or drowning. The
ignition safety switch and lanyard are to
prevent the boat from becoming a
runaway if the operator is accidentally
thrown away from the helm. With the
engine(s) running, pull the lanyard off
the ignition safety switch. Engine(s)
must stop running. If the engine or
engines do not stop running,
immediately see your authorized Cobalt
dealer for service.
COB_0079_A
TEST
RESET
A
DANGER
Avoid fire or explosion. Whenever
checking for electrical problems, use
extreme caution. Fuel and fumes are
extremely flammable and explosive.
COB_262_OM_forWeb.book Page 3 Friday, June 9, 2006 3:14 PM
