BAT32G1x9 user manual | Chapter 25 Linkage Controller (EVENTC).
1046 / 1149
Rev.1.02
Table 25-3
ELSELRn register (n=00~2 2) correspond to the operation of the link target peripheral function
when it accepts an event
ELSELRn register
ELSELn3~ELSELn0
bits
Link target
No.
Link target peripheral
functionality
Run when the event is accepted
0001B
1
A/D converter
Start A/D
conversion.
0010B
2
Timer input for Timer4
channel
0
Note
1
Delay counter, measurement of
input pulse interval, external event
counter
0011B
3
Timer
Input
Note
2
for the timer4
channel 1
Delay counter, measurement of
input pulse interval, external event
counter
0100B
4
Timer A
Count the sources
0101B
5
Timer B
Input capture for TBIO1
0110B
6
Timer M
TMIOD0 input capture, forced cutoff of pulse
output
0111B
7
Timer M
TMIOD1 input capture, forced cutoff of pulse
output
1000B
8
DA0
Note
3
Real-time output
1001B
9
DA1
Note
3
Real-time output
Note 1
To select the timer input of Timer4 channel 0 as the link target peripheral function, the operating clock of channel 0 must first
be set to the operating clock of channel 0 through the timer clock selection register 0 (TPS0). fCLK, enable register 1 (NFEN1)
to set the noise filter at the TI00 pin as OFF (TNFEN00=0), and the timer input used by channel 0 is set to the event input signal
of the linkage controller via timer input select register 0 (TIS0).
2. To select the timer input of Timer4 channel 1 as the link target peripheral function, the operating clock of channel 1 must first be
set to the operating clock of channel 1 through the timer clock selection register 0 (TPS0). fCLK, enable register 1 (NFEN1) to
set the noise filter at the TI01 pin as OFF (TNFEN01=0), and the timer input used by Channel 1 is set to EVENTC via timer
input select register 0 (TIS0). event input signal.
3. If you want to enter the deep sleep state when the real-time output mode of the D/A conversion is active, you must disable
event links for EVENTC before entering the deep sleep mode.
