page 18 of 30
All content © 2019, cmotion GmbH. All specifications are subject to change without further notice.
http://www.cmotion.eu
6.5. Setting up the cPRO
camin´s command mode
6.5.1.
to enable wireless for non-wireless devices
1. Connect your non-wireless LBUS device; i.e. pan-bar zoom, steady zoom, Master Grip or
OCU-1 to the cPRO camin using an LBUS - LBUS cable or a CAM - LBUS cable.
2. Supply power to the daisy chain through the cPRO camin´s CAM or LBUS connector, or
alternatively, through the LBUS device.
3. Set the cPRO camin to “client”. In order to switch between master and client, simply press
and hold the upper button on the cPRO camin for 3 seconds. Then, select master or client
with the up/down buttons and wait for 5 seconds to enable the function.
4. Set the cPRO camin (client) to the same radio channel as the cPRO camin / cPRO motor
(master) on the camera side. Once both units are set to the same radio channel, the two
devices will connect automatically.
5. If multiple cPRO camin or cPRO hand units are used, please set all devices you want to
connect to the network to the same radio channel (please also refer to the user manual of the
cPRO hand unit). Up to 2 wireless devices (clients) can be connected to one cPRO camin /
cPRO motor (master) at a time.