page 11 of 30
All content © 2019, cmotion GmbH. All specifications are subject to change without further notice.
http://www.cmotion.eu
5.1.1.
Soft buttons
Two soft buttons are located below the display. They change their function depending on the
screen content.
5.1.2.
Menu navigation
Use the soft buttons to enter the setup menus as follows:
Buttons
Press button...
Menu
Upper button
Short
Change RF channels 0-13,
counting up
Lower button
Short
Change RF channels 13-0,
counting down
Upper button
Long (3 sec)
Enter “command mode” to
switch between “master” and
“client”
Lower button
Long (3 sec)
System info
Lower button
Long (6 sec)
Region settings
Both buttons
Long (6 sec)
Factory reset
Note: The main screen turns off after 3 seconds.
5.2. Setup
5.2.1.
Radio channels
The RF menu lets you select the radio channel.
Press the lower or upper button momentarily to enter the radio menu.
The upper button allows you to change the RF channles from 0 - 13, the lower button allows
you to change the RF channels from 13 - 0.
Toggle through the channels until you reach the desired radio channel. The channel will be
set automatically after three seconds.
5.2.2.
Command mode
This unique feature allows you to use any cPRO camin as a master or client, at the push of
a button to create a wireless solution for any LBUS controller.
Simply connect your non-wireless LBUS device; i.e. pan-bar zoom, steady zoom, Master
Grip or OCU-1 to the cPRO camin, connect it to a power source and set the camin to “client”.
The cPRO camin will then transmit wireless command signals to the “master” (cPRO camin /
cPRO motor) on the camera-side.