CMi C-EKS-2000/35, Original Instructions Manual

Page: 57 / 224

GB
57
– Make these materials available for recy-
cling.
Technical data
*) The specified values are emission values and do not necessarily
represent safe workplace values. Although there is a correlation
between emission and immission levels, this cannot be used to
infer whether additional safety measures are necessary or not.
Factors which affect the current immission levels at the work-
place, include the type of room, other sources of noise, e. g. the
number of machines operating and other processes taking place
in the vicinity. Permitted workplace values can differ from coun-
try to country. This information is designed to help the user to
better assess the dangers and risks. Determination of noise
emission values in accordance with EN 60745-1.
**) The specified vibration emission value was measured in accord-
ance with a normed test procedure and can be used in order to
compare one tool with another. The specified vibration emission
value can also be used for an introductory evaluation of the
exposure. The vibration emission value may fluctuate from the
specified value during actual use of the power tool. These fluc-
tuations will depend on the way in which the power tool is used.
Try to keep vibrations to a minimum. One method of reducing
the vibration load is, for example, limiting the length of time you
work with the tool. All parts of the operating cycle must be taken
into account for this purpose (for example, also including times
in which the power tool is switched off and times in which it is
switched on, but is running without load). Determination of vibra-
tion emission values in accordance with EN 60745-1 &
EN 60745-2-13.
Appropriate chain oil
Use only special saw chain oils with good
adhesion properties. Since the saw chain oil
can penetrate the environment during opera-
tion, biologically-degradable special vegeta-
ble-based saw chain oils should be used.
Item number 234853
Nominal voltage 230 V~, 50 Hz
Nominal output 2000 W
Protection class II
Cutting speed 13,1 m/s
Idling speed 7000 min
-1
Cutting length 355 mm (14")
Oil tank capacity 110 ml
Noise pressure level
(L
PA
)*
90,2 dB(A)
(K = 3 dB(A))
Sound power level (L
WA
)* 103,2 dB(A)
(K = 3 dB(A))
Vibration** < 6,57 m/s²
(K = 1,5 m/s²)
Saw rail Oregon 14''
518304
Trilink
M1501452-
1041CM
Saw chain Oregon
91PJ052X(14'')
Trilink saw
CL15052PB
NOTICE! Risk of damage to the
device!
Under no circumstances
should you use old oil to grease the
saw chain! This can cause damage to
the oil pump, saw rail and chain!