127
mm
150
mm
538
mm
55m
m
490m
m
705m
m
635mm
max.
Use 2.5mm Allen key to
loosen grub screw and
allow arm assembly to
drop into base stem.
Designed to fit onto desks with 19-30mm
thickness with the included clamp.
Carefully insert the pin
at the bottom of the
arm assembly into the
base stem.
If 180° lockout is
required, ensure bush
protrusion sits in recess
at bottom of the arm.
Tighten the grub screw
to secure the arm
assembly to the base.
Do not overtighten.
Use 4x M5x25mm bolts
to fix the handle and
horizontal rail to the
head of the arm.
The rail is now fully
assembled and ready
for the monitors to be
installed.
Fix quick release VESA
in place with supplied
fixings. 4x M4x12/16mm
CSK pozi screws.
Align the raised square
section on the VESA
with the recess on the
rail mount.
Lower the monitor onto
the rail mount until it
clicks into place. Repeat
for the second monitor.
To remove the monitors,
start by disconnecting
any cables.
Depress the lever at
the top of the VESA to
release it from the rail
mount. Lift up monitor.
The arm may try to
spring up as the weight
is removed. Guide the
arm to prevent this.
The nylon bush can be
removed, flipped and
refitted to remove/apply
the 180° lockout.
Flip the bush over so
the protrusion faces
upwards to apply the
180° lockout as shown.
Place the clamp cover
over the base with the
recess facing the desk
edge. No fixing required.
Ensure the EVA pad is
applied to the bottom of
the base to protect the
desk surface.
Use the supplied M8x20mm grub screws in the clamp if more thread is required
Place base on desk with
recess facing the edge.
Offer up the clamp to
the base as shown.
Use 4mm Allen key to
tighten the 2x grub
screws in the clamp into
the base.
Mounting the base to the desk
Dimensions
Installing monitors
(max width of 635mm/25” per monitor)
‘CLICK’
Nylon bush in no lockout
position
Nylon bush in 180° lockout
position
2.5mm
4x M5x25
8x M4x12
8x M4X16
8mm
4mm
6mm
Installing the arm and horizontal rail
Reach Plus Dual
Installation, user and care guide
Contents
x1
x2
x1
x1
x2
x1
x1
x1
x1
x1
x1
x1
x1
2x M8X20
Add pad to
clamp if
required
Part No: 134222 Issue No: 004
