Club Car XRT 950 2009, Maintenance And Service Manual

Page: 37 / 256

BODY AND TRIM Under Seat Closeout Panels
4
4. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles on page 1-4.
5. Remove the two bolts that secure the top of the side panels and the under seat closeout panels to the frame
(Figure 4-25, Page 4-13) .
6. Manipulate and flex outer closeout panels to unclip them from the lower seat support frame (Figure 4-26,
Page 4-13) .
1073
Figure 4-25 Closeout Panel Removal – remove side panel
bolts
974
Figure 4-26 Closeout Panel Removal – unclip from lower
seat support frame
7. Rotate each outer closeout panel until it can be easily removed from the seat back support frame (Figure
4-27, Page 4-13) .
975
Figure 4-27 Closeout Panel Removal – rotate to remove
8. Remove outer closeout panels from vehicle.
UNDER SEAT CLOSEOUT PANEL INSTALLATION
1. Install under seat closeout panels in the reverse order of removal. Tighten bolts to 22 in-lb (2.5 N·m).
2. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles on page 1-4.
2009-2012 XRT 950 Maintenance and Service Manual Page 4-13